I have a friend I rarely get to see and while email and texts are
nice, a personal, and fun, greeting card are a sweet touch every now and
then. I found a card that I felt summed
up our 20+ year friendship that was perfect and all I had to do was to add a
flower that was full of wildflower seeds that you can actually plant and grow!
I made my seed flower and after it dried I created a beautiful
little Bowdabra bow in green satin ribbon. After the seed flower dried I
attached it to the front of the card and it was ready to mail. I included instructions to remove the flower,
place on the ground and cover with a bit of soil. Then water thoroughly. That’s all there is to it.
Materials:
Bowdabra bow maker or optionally purchased bow
Bowdabra bow wire
7 ½” 3/8” wide green ribbon
All purpose paper
Blender
Pack of wild flower seeds
Flower cookie cutter shape
Hair dryer
Greeting card
Tacky craft glue
Small bowl
Paper plate
Sponge
Food coloring and small paintbrush
Instructions:
1.
Tear the all purpose paper into small pieces and
place in the blender. Add water just
enough to cover the paper and let sit for a few minutes. Next pulse the paper in the blender to create
a pulp. Pour out excess water and remove
the pulp with your hands over a sink squeeze out most of the water till it is
pulpy and not soupy.
2.
Next place the pulp into a small bowl and stir
in the wildflower or other seeds. Then
press the pulp/seed mixture in a cookie cutter shape on a paper plate.
3.
Now use the sponge to press on the pulp to soak
up any excess water. Keep doing this for
a few minutes then remove the cookie cutter.
4.
You will want to dry the shape as much as
possible so you use a hair dryer on low.
Work to dry one side and then turn over and repeat on the other side. It will still be slightly damp. Set aside and dry overnight. After it is completely dry the shape will be
hard and set.
5.
Now you can use some food color to brush on some
color if you choose or leave it as is.
6.
Make the bow.
Cut a piece of Bowdabra bow wire 18” long, fold in half and place in the
Bowdabra.
7.
Cut a piece of 3/8” wide green satin ribbon 7 ½”
long. Use a lighter to seal the ends of the ribbon. Fold in half to find the center
point and insert into the Bowdabra.
8.
Make a loop to the 1” mark and insert into the Bowdabra. Make a matching loop on the other side. Scrunch down with the Bowdabra wand.
9.
Insert the two loose wires through the bow wire
loop to make a slipknot. Pull tight
while the bow is still in the Bowdabra.
Separate the wires and tie a knot.
Cut the wires short. Add a bit of
tacky glue on the card and attach the seed flower. Then add a bit more glue and attach the bow
under the flower. Let dry and your
greeting card is ready to send…and the flower is ready for the recipient to
plant and enjoy!
This is truly BRILLIANT!! Thanks Crystal! Happy Easter! Big Hugs!
ReplyDelete