How to use a simple technique to make super fun spring friendship bracelets

In this easy DIY tutorial, you will learn how to easily make some fun spring friendship bracelets in just minutes with just a few supplies.  

Materials:

Pack of Green and yellow mini rubber bands or desired two colors

Two pencils

3 inches of wrapped floral wire

Wire cutters

Needle nosed pliers

Ruler

Instructions:

First, place two pencils side by side. Next, slide a green rubber band in a figure-eight shape on the pencil. (See photo) Next, slide on a yellow rubber band, and then a green one.  You just need to slide these on without a figure eight. (See photos)

Now, lift the bottom rubber band and pull it over the top of the pencil. Repeat on the opposite side. (See photo)

Add a green rubber band and repeat step #2.  Continue adding rubber bands and pulling over the top alternating green and yellow.  You will start to see a chain forming in between the pencils.  As it grows, pull on it slightly to keep it even.

Keep adding bands to make the chain longer until you have a length to fit adjusting the wrist. Factor in the size of a one-inch wire curl closure.

Using the wire cutters cut a 3-inch piece of wrapped floral wire. Next, Insert the wire into the loose end of the chain loops.  Curl the wire end around the rubber band loop.

Remove the other end of the chain from your pencils and insert the uncurled end of the wire in both loose ends. Now, curl it around as you did the other side and adjust if necessary.